Cast Bronze Plaque Mounting Method Options

 

PLAIN MOUNT

Plaques with no mounting hardware that can be attached to mounting surface with a combination of adhesive or double-faced tape – based on surface and plaque weight.

BLIND STUD MOUNT

Back of plaque is drilled and tapped to receive threaded studs. Studs are pressed into pre-drilled wall holes and secured with adhesive and/or anchors – based on the wall type and letter weight. Studs can be aligned in-line for brick or block mortar upon request

 

SOLID WALL

 

Machine screws, passing through plaque holes, with or without decorative rosettes. Screws are either bonded into wall holes with adhesive or a combination of adhesives and anchors – based on wall and plaque size and weight. 

HOLLOW WALL

 

Machine screws with toggle, passing through plaque holes, with or without decorative rosettes. Screws are then tightened to expand toggle in a hollow wall cavity.

WOOD MOUNT

 

Wood screws, passing through plaque holes, with or without decorative rosettes. Screws are screwed into a wooden wall surface or bonded with adhesive to further secure.

 

GARDEN STAKE

 

Machine screws are inserted through 5/16”-thick black anodized stakes into the back of the plaque. Maximum plaque size is 12” x 8” for one stake or 20” x 8” for two stakes. Available in heights of 24”, 36” and 48”. 

 

POST CAP

 

Cast as part of an aluminum or bronze plaque, the post cap mount is designed to fit on 1-1/2", 2" or 3" ID schedule 40 posts.  Available on almost any custom plaque, single or double-sided, up to 30" x 30".  Post sold separately.